PowerSpark Installation Guide

Welcome to the ShinePay PowerSpark Installation Guide. This guide will walk you through each step needed to install a ShinePay PowerSpark with any Machine. The PowerSpark installation requires a certified electrician to complete the setup. Always proceed with caution while working with live power. 

The PowerSpark controls your appliance by controlling power to your appliance. This allows you to accept payments on any appliance that takes power. The PowerSpark is located inside a pre packaged junction box. 

The final installation looks like the setup below. You have two options for the installation. 

Option A (below): Wire your PowerSpark to a single outlet which will control whichever machine is plugged into the outlet. 

Option B: Hardwire your appliance directly to the PowerSpark. 

Step 1

Open the junction box by loosening the 4 screws

Once the junction box is open you will see 3 screw terminals towards the top and right. This is where you will be connecting your appliance and power source. Each terminal is clearly labeled on the board for your reference. 

Step 2

Surface mount your junction box to the wall. For best results your PowerSpark should be within 15ft of your appliance. 

Once your PowerSpark is mounted to the wall feed the power source's Hot, Neutral and Ground wires into the junction box. 

Step 3

Feed the power source's Hot, Neutral and Ground through the conduit where where you will wire it to your outlet. 

Step 4

Attach round wire crimps to your power outlet and power source's neutral wires then secure them both to the top center terminal labeled 'Neutral White Wire'

Step 5

Attach a round wire crimp to your appliance's hot wire then secure it to the terminal labeled 'Black Wire Out'

Step 6

Attach a round wire crimp to your Power Source hot wire then secure it to the terminal labeled 'Black Wire In'

Step 7

Take note of the label number on the inside wall of your PowerSpark (in this example 187643). Attach the matching QR label to your machine along with its 'Pay with your phone' label. 

Step 8

Screw the cover back onto your PowerSpark. Your PowerSpark installation is now complete. For questions please email support@shinepay.co